5/17/2023 0 Comments Virtual cable discord![]() ![]() ![]() Start voice chat with a friend and test if that works.In Discord, select CABLE Output as the Input, and the interface output as the output (same as Cubase).In the Control Room instance, mute your Mic instance and vice versa so they don’t feed back into each other (this is critical).Connect the three Sonobus instances together.Open Sonobus as standalone (you should now be having three instances), and select CABLE Input as the output (do not set any input).If you have a USB or wireless microphone, then use a standalone instance instead, but then only set the input (no need to set an output). Add another instance of Sonobus on your Mic Input Channel.In Cubase, add a VST instance of Sonobus on your Output Channel or in the Control Room. ![]() ![]() The better way is to install Sonobus and Virtual Cable. That way other people won’t hear themselves, but it is a bit more complicated to setup and you need an appropriate interface. I let you imagine if two or more users are using loopback at the same time, that would create an endless feedback loop, which is not what you want.Ī workaround can be to have a Focusrite interface with S/PDIF connectors and use physical loopback (put the S/PDIF Out into the S/PDIF In) and do the appropriate routing in the Focusrite Control mixer so that only the outputs of Cubase and your Mic go into the loopback, and select the S/PDIF Input in Discord. It will transmit everything that goes into the interface output (in short, everything that you hear) plus the mics that are plugged into 1/2, but then, that would be problematic since, when other people are talking into Discord or such apps, they would hear themselves in return. If you want to use a mic without having to monitor it through the output, it’s this second option that should interest you. Some interfaces have both a dedicated Virtual channel and an option to merge it with the 1/2 input. The easiest way ( but not recommended) would be to enable Loopback on your interface, and set the loopback channel as the input in Discord. There are several ways to do what you’re aiming to, but some are better than others : First, if you are on Windows, you should make sure to follow these few steps, if not done already. ![]()
0 Comments
Leave a Reply. |